Cleaning up the plenum (or trading for a polished one) 27. Disconnect any hoses going to the throttle bodies (39. & 40.). Remove all the hoses and tubes from the underside of the plenum (4 x 10 mm bolts and a lot of hose clamps) (41.). Remove the idle air …

Install 8 12mm bolts for plenum. The short bolt goes in the front passenger side. Blue circle in (93.). The stud bolt goes in the 3rd hole from the front on the passenger side (stud is to attach the throttle cable cover to). Green circle in (93.) Torque all bolts to 12-15 ft. lbs. (1.6-2.1 kg-m).

Apr 26, 2004 · 11. On the rear of the plenum toward the passenger side, remove the clamp and remove it from the metal tube 12. Remove the EGR vacuum line at the solenoid location. 13. Remove the plenum bolts at the top middle of the plenum (8 x 12mm) (NOTE: the shortest bolt is by cylinder 1, and the bolt with a hex top for the throttle cable cover is by ...

Jan 11, 2010 · 90-93 300zx Part Out, 94 TT Tan Interior Trim Contact Information: Name: Matthew P. Cell Phone: 817 723 7064 (call or text) Email: t3rm1n80r07 *(@)* yahoo.com I need to get all this stuff sold so I can finish building my motor for ...

Jun 9, 2009 · Plenum torque sequence ?? >>>>> Posted by: jeff1954 on June 07, 2009 at 3:30 AM : This message has been viewed 508 times. Message: I've got a factory service manual for my '91 NA, and there's no torque pattern (sequence) for the main plenum bolts (among many other Nissan omissions) in it. Anybody ever found one from another year FSM maybe ?

Dec 8, 2016 · New Single intake plenum design : Posted by: Alan(MD/NJ) on December 07, 2016 at 7:20 PM : This message has been viewed 1757 times. Message **First off, I'm all for new innovation and have no connections or affiliations with this company**

Oct 14, 2008 · Since you have a 93 then just get the 300 degree rails >> Posted by: ZUL8TR on October 14, 2008 at 8:44 AM : This message has been viewed 249 times. In Reply To: Machined lower plenum for 95+ style fuel system posted by J-Mart on October 13, 2008 at 05:37 PM : …

Dec 8, 2005 · Grinding the plenum with the Dremel so that the cap screw by the red arrow will come out. Use a Shop-Vac and a helper to suck the metal filings as you grind. Get straight over the top of the injector and look down between grindings. Remove the screw on the non-Dremel'd side first for a little more "fudge" room with the remaining screw.

Body is 8/10. Paint is good some rock chips in front and very light swirl marks. spoiler is starting to crack. Interior 8/10. Drivers seat has a hole on the left bolster from getting in and out of car, shifter boot is peeling a little. New 02 sensors, t/p sensor, maf, fuel filter, fpr and damper, clutch slave. Deleted under plenum coolant lines.

Apr 17, 2011 · 7. Pulled and dremeled the plenum and replaced all six injectors with new OEMs, new PCVs, and did TB bypass -engine runs noticeably smoother at idle, power is about the same, hesitation still exists. 8. Hesitation issue persisted after VTC solenoids and EGR were turned off. 9. Desperate, I questioned the timing belt setting by the previous owner.