Plug-n-Play with our existing system. The new design moves the adjustable pressure switch post filter, so it will read true pressure from the liquid the nozzle is seeing. There is 30 inches worth …

May 28, 2017 · My buddy did the alky wires from the pump in to the map sensor and ran them across to my glove box. I finally got around to finalizing the control install in the glove box this …

Aug 22, 2015 · Before you tight the mount bolt up, make sure to connect the pump wiring connector to the shielded wire we ran earlier. Next connect the 28” braided line we ran earlier …

once pump is set in place. Now pull wire loom off and use the supplied ¼ bolt to bolt the pump to the wire loom hole. Next is install the feed hose and tighten its fittings. Remember these …

Aug 2, 2015 · First off, I have NO red wire with an O-ring or terminal connector on it, and I have NO long red wire. I'm tempted to just scan all the pages for the instructions so everyone can …

Feb 16, 2024 · Installed a pressure sensor in the alky line (not totally necessary but highly recommended) and connected a SSR (solid state relay) to feed power to the pump, controlled …

Brand New for August 2021. Pump and Switch. Plug-n-Play with our existing system. The new design moves the fully adjustable pressure switch post filter, so it will read true pressure from …

Jul 5, 2013 · Here is my Official "How-To" on the installation of my Alky-Controls/LMS 100% Full Methanol Injection. To start, I must thank the following four people for providing technical and …

May 31, 2001 · Got an external pump from alky control to replace my in-tank pump on my SMC Alky. The red and black wire seem pretty simple, hook to the black and red on new pump. I …

PAGE 1. Kit Packing C7 Vette PAC controller Pump w/4 Feet shielded cable 4 Feet 7/16 split loom 6 Feet ¼ split loom 2 long wire ties PAC wiring + DS tape 7 inch hose –6 -6 28 inch hose …